Tools Needed to Do this Job:

Screwdrivers - (Flat and Phillips)
Wire Strippers
Wire Crimpers
Wrenches 10mm, 3/8, and 7/16
Alcohol based cleaner
Heat gun or Blow dryer
Solder gun
Wire Solder
Scissors



Instructions:

1. Make sure your bike is cool and parked on a flat secure surface before you start to install your Motorcycle Led Lights!

2. Find your battery (you may have to remove your seat or side covers in order to get to your battery) Disconnect the NEGATIVE ( -) cable.

Negative battery cable must be disconnected from the battery in order to avoid safety hazards! Be sure as you disconnect the Negative cable that it does not touch or make contact with your Positive terminal.

3. Your new motorcycle LED lights are polarity sensitive—meaning that the RED wires on the LEDs must be hooked to the Positive (+) terminal and the BLACK wires must be hooked to the Ground (-) .
All Red Wires must go to a common power wire and ALL Black Wires must go to a common ground. You cannot run the motorcycle LED lights in a series nor can you run the wires from one LED to another in a loop type installation. (All of the wires on the motorcycle LED lights which you install will end up together in one place at your battery.)

4. Pick a hidden flat surface around the front of your seat area to mount the switch. (You must be able to reach the switch when the seat and / or side covers are back on your bike.) You will install your switch later using the double-sided tape provided to you.

5. Next, begin choosing the locations where you would like to mount your motorcycle LED lights. Choose areas which will give you the most light coverage overall, but which will allow the motorcycle LED lights itself to be hidden from easy view when you are standing back and looking at the bike.

6. Clean each area where you choose to place a motorcycle LED light with the alcohol based cleaner making sure all dirt and/or oil is removed from that area.

7. On the LED fixture peel off the covering on the double-sided tape and press the fixture very firmly onto the area you have chosen. Repeat this with each motorcycle LED light you are installing. (You will deal with the wiring in the next step)
    * *  If you need to change the position of one of the fixtures—grasp the fixture firmly and then gently twist the fixture back and forth, as you feel it loosen pull it loose and reposition it. Do not use major force to just pull it loose—you may break the fixture. Twist back and forth and you feel it begin to loosen.

8. Now you will begin to bring all of the wires together in the battery area of your bike. (As you run the wires toward the battery area try to keep them hidden from view once you have replaced your seat / side covers. You can also run them beside other wiring in your bike.)
    *  Your goal is to not be able to actually see the motorcycle LED lights / wiring when your bike is reassembled and you are standing back a short distance and looking at it.

9. Depending on where you have placed the motorcycle LED lights and the type of bike you are working on, some of the wires may not reach all the way to the battery area. You will need to extend the wires with the extra wire provided to you.


    ** TROUBLESHOOTING: All of your motorcycle LED lights are tested before they are packed to ship to you. If you have a problem with them lighting it is almost always due to a faulty connection, or by having wires connected backwards. Re-check all of your connections and check that the right wires are connected to the right wires. Usually--it is one of those 2 problems that are easily correctable.